Build: 650X6

DSC00570

It’s been a while since we built a hexacopter. We’ve chosen the Hobbyking 650X6 for it’s affordable price. This will be more for use to lift heavier loads with redundancies.

DSC00571

When folded this hex is 9250mm with 10 inch prop from center motor to opposite center motor.

680mm motor center to motor center and width 340mm when folded.

When opened and ready to fly, it’s 680mm than the named 650mm X6.

DSC00508

Above: No love for the 650X6, not even a box. It comes in plastic bags. You pay for what you get. It’s only USD $29…

DSC00509

One page instruction.

DSC00510

Tubes are 15mm x 15mm

DSC00511 DSC00512

Above: Design of the motor mounts. Cumbersome and hard to install thus we only installed only 2 of them…it lead to bad choices. See flight video at the end.

DSC00513 DSC00514 DSC00515 DSC00516 DSC00517 DSC00519 DSC00521 DSC00522 DSC00523 DSC00524 DSC00525

Motors fitted, Emax 2213 with 10 inch prop. Going to run 4S on this.

DSC00526 DSC00527 DSC00528 DSC00529

Above: Note the mounting of the horizontal bars under the hex for these are about 71mm center to center of hole on the rubber.

DSC00530 DSC00537 DSC00538

Above: Messy cabling, get it flying first. Tidy up later.

DSC00539 DSC00540 DSC00541 DSC00542 DSC00543 DSC00544 DSC00545 DSC00546 DSC00547 DSC00548 DSC00549 DSC00550 DSC00551 DSC00552 DSC00553 DSC00554

Build:

– Hobbyking 650X6
– Emax 2213 motors
– Gemfan 10 inch propellers
– 4S 5200mha Multistar
– DJI Naza M V2 with GPS, miniOSD
– Frsky D4R II

Flight:

Nothing broken but one motor came off during flight. We did hear some wierd sound thus the really low flying and came close to take a look…then flew out and the motor came off. Time to install more of those cumbersome nylon poles.

Leave a Reply

Your email address will not be published. Required fields are marked *